Fox & Hound training now available

Fox & Hound training now available

Have a Fox & Hound kit? Thinking about getting one? Unsure of how it all works? We have a training module that will teach you the ins and outs of the kit. Learn each menu and all of the buttons presses, how do use the kit for testing cables, troubleshooting, and more. Check it out here:

https://www.murideo.com/fox-hound-training.html

    • Related Articles

    • HDMI cable test with Murideo test equipment

      Here are the steps needed to perform an HDMI cable test with the Murideo Six G/Six A test kit   1) Connect the HDMI cable that you would like to test to the Six G 2) Connect the other end of the HDMI cable to the Six A 3) Power up both units 4) Press ...
    • Testing infrastructure before a retrofit job

      It is not uncommon for an integrator to take on a project where new A/V components are to be installed using existing wiring and infrastructure. Often times the customer is upgrading to a modern A/V system in an environment where an older system was ...
    • F&H generator not outputting 8k signals

      We have received reports that the F&H generator will not output 8k FRL signals when connected to the analyzer. The symptom is "no signal" on the analyzer, and both "HDCP" and "Status" lights continuously blinking on the generator.  There is nothing ...
    • Sony - Which types of 8K and 4K video signals are supported by the Android TV or Google TV?

      Here is a full list of which Sony TVs support which video formats. This list covers all models back to 2014. Take note that some models will require the use of a specific input for 8k signals.  Sony suggests these essential tips before installation ...
    • Understanding FRL - Data rate chart

      Now that HDMI 2.1 is here, there had been some confusion on FRL, TMDS, and data rates. The attached chart should help clarify some of the confusion! HDMI 2.1 features some new tricks that allow for the better transport of audio-video signals. One of ...